5 Steps in Doing Software Vulnerability Management (Knowing the Order)

If you are a common people, maybe you will feel unfamiliar with the title above. However, if you are a programmer or software developer, the words vulnerability management may be familiar, or even your daily activities.

Vulnerability governing is a sentence commonly used by programmers and developers to mention a continuous checking process. These activities are carried out to minimize potential errors.

Data Collection

Data Collection
Image Source: dma.org.uk

In the first stage of conducting a vulnerability assessment, you must record the entire structure of assessment target, and then submit it to the management inspector application. At this stage, you must be prepared to collect a lot of data in your database.

Although it involves a lot of data and variables in it, the management inspector application won’t directly check the data. It will only summarize it into a large inspection list, so inspecting activities will be much easier and structured.

Equal inspection

After successfully recording and mapping the entire data to be examined, the vulnerability management application will begin checking it one by one. It will check various types of data damage based on benchmarks they have prepared in advance. The benchmarks consist of:

  • Virus
  • Wrong and malfunctioning code
  • Unsafe application
  • Suspicious permission requirement

Repair effort

After going through the inspection phase, much of your code and program will be filtered and separated between the good and the errors. After that, the management inspector will categorize the data based on how bad the damage it has.

When finished sorting out the errors in the code starting from the lightest to the heaviest, the management inspector will begin to repair the damage that could be saved. The success of this process depends on how strong the application is.

Error report

Obviously not all damaged data can be repaired, and for data that cannot be repaired, the management inspector will provide annotation mark on the data, equipped with error code.

Usually, the data that is given annotation is data that is misconfigured, so even though the implications can be fatal, but the handling is quite easy, especially if the handler have experience in the field of error-repairing.

Rinse And Repeat

Rinse And Repeat
Image Source: tripwire.com

Contrary to popular belief, it turns out that the data cleaning phase doesn’t stop here. When finished reporting the errors in the target data, the inspector management application will again repeat the checking procedure starting in the first stage.

Repetition efforts will continue continuously, adjusting to the settings that you have set at the time of pre-inspection. Keep in mind that the longer the application takes, the longer you can run your program.

That is the 5 stages in error checking of data programming or software. Although at first glance it looks easy, these 5 stages require more attention and consistency, to produce programs that work well.

That’s why many software companies end up relying on service providers to conduct vulnerability management, which they will try as much as possible within the specified deadline to ensure the program and its applications run perfectly.

Add a Comment

Your email address will not be published. Required fields are marked *